Nilfisk-Advance 56108110 SC8000 48 LPG, Руководство по обслуживанию

Страница: 219 / 225

eel S ste raction Service Manual – SC8000
e oval an nstallation
arnin e ore re ovin or reinstallin an ac ine co onents a e sure t e e s itc
is o t e e is re ove ro t e ac ine an t e ar in ra e is en a e
us ull Control Ca le e lace ent
1. Lower the side broom(s).
2. Empty and remove the recovery tank.
Caution Ma e sure to ollo t e instructions in t e eneral n or ation ac in t e Mac ine
section ac t e ac ine at t e esi nate locations onl
3. Block the rear wheels.
4. Jack up the front of
the machine. This
will make it easier
to access the
Push/
Pull Control Cable
and
mounting hardware
by the foot pedal
assembly.
5. From underneath the
machine, note the
position and spacing
of the two jam nuts
and star washer
holding the old
Push/
Pull Control Cable
in
the mounting fork by
the foot pedal. Loosen
the jam nuts and
remove the
Push/Pull
Control Cable
from the
mounting fork.
6. Disconnect the rod end on the old
Push/Pull Control Cable
from the foot pedal assembly.
7. Loosen the locknut, then remove the rod end and locknut from the
Push/Pull Control Cable
.
8. Remove the two jam nuts and star washer from the old
Push/Pull Control Cable
. (This will make it easier
to remove the old
Cable
from the machine.)
9. Loosen the jam nut holding the old
Push/Pull Control Cable
and
Hydroback Centering Unit
in the mounting
fork by the
Piston Pump
.
10. Disconnect the
Rod End
from the
Piston Pump Lever Weldment
.
11. Loosen the locknut, then remove the
Rod End
and locknut from the old
Push/Pull Control Cable
.
12. Remove the four jam nuts and two star washers from the new
Push/Pull Control Cable
. (This will make it
easier to pull the new
Cable
through the machine.)
Hydroback
Centering
Unit
Push/Pull
Control
Cable
Piston Pump
Lever
Weldment
Piston
Pump
Rod End
Hydroback
Adjuster
Plate