Niles IntelliControl ICS, Инструкция по установке и настройке

Страница: 53 / 70

53
(800) BUY-HIFI NILES AUDIO CORPORATION
CONFIGURING THE GXR2
SELECTING A PLACEMENT
SITE FOR THE GXR2
Like any high-fi delity component, the GXR2 will last much
longer if it is given adequate ventilation for proper cool-
ing. When installing the GXR2 in a cabinet, be sure that
the cabinet’s rear is open to receive fresh air in order to
provide proper cooling. If the cabinet’s design does not
accommodate an open rear, install two small “boxer fans”
to provide continuous airfl ow into and out of the cabinet.
Place the GXR2 so it has at least seven inches of free air
space above it. If the receiver is located on a carpeted sur-
face, place a board under the receiver’s feet. Do not block
the ventilation holes on the top and bottom of the GXR2.
INSTALLING RACK EARS
TOOLS REQUIRED:
• Screwdriver with No. 2 Phillips bit
1. Remove the four chassis screws located at the front
of one of the IntelliControl ICS GXR2 Modular
MultiZone Receiver side panels.
2. Place a rack mount panel on the GXR2 side panel,
aligning the holes in the rack mount panel, with the
holes in the GXR2 side panel.
3. Replace all four screws, fastening the rack mount
panel to the chassis.
Note: Do not over tighten the screws.
4. Repeat procedure for the other side of the GXR2.
INSTALLING SOURCE CARD
MODULES
WARNING: Always turn the power OFF on the
Intellicontrol ICS Modular MultiZone Receiver and be
sure the AC line cord is disconnected to avoid damage
and electrical shock before making any connections to
the card module.
CAUTION: The card module is susceptible to static dis-
charge. Be sure to use a grounding strap or touch an
earth ground prior to picking up the module. Handle the
card by its edges.
1. Carefully slide the card module into the appropriate
card slot. (Refer to the GXR2 Installation Worksheet
to assure proper card slot number.)
2. Concentrate on the GXR2 card cage guides as you
insert the module card.
Inserting the module card into the GXR2 card cage
3. Be sure the multi-pin connector is secured to the
header in the card cage.
4. Tighten thumbscrews. (Do not over tighten.)
'.
"/5
5.
".'.
".
"/5
-
3
$"4$"%&"6%*0
065
/JMFT"VEJP$PSQPSBUJPO.JBNJ'MPSJEB64"
Guides
CONFIGURING THE GXR2
Make sure that there is a minimum
of 7” of free air space above the
amplifi er and 3” on each side for
proper ventilation..
If the cabinet rear is not open to fresh
air or if you’re using low-impedance
loads, install two “boxer fans” to
provide continuous air fl ow into and
out of the cabinet.
. 0 % 6 - " 3
. 6 - 5 * ; 0 /
& 3 & $ & * 7 &
3
(93
Rack Mount Ears
Flange for butting
bracket against
a joist
Fastening the Rack Mount Panels.
Allow a minimum of 2” of depth
behind unit to accommodate cables
and connectors.
Boxer Fan (55 CFM) directly centered
7” on top and in back of the GXR2. CAUTION!
When using low-impedance speaker
loads (less than 8 ohms Nominal)
you must use boxer fans as shown.