background image

PN 72964 TRI-TRAN™ Wireless Keypad Installation Instructions. Revision 1.02 A 

TRI-TRAN™ WIRELESS KEYPAD

INSTALLATION INSTRUCTIONS

PART NO 062269

Tri-Tran™ Wireless Digital Keypad is designed for use with automatic 
garage door and gate openers. The Tri-Tran™ format provides 
unparalleled security with more than 99 million different codes. To 
operate, the user enters their unique pin code on the Wireless Keypad (4 
to 8 digits long) followed by the hash (#) key. The user then presses one 
of the eight available channels.

Familiarise yourself with the following instructions prior to commencing 
set up. Store this information including your new pin code in a safe place 
for future reference.

Initial Set Up

The Wireless Keypad is supplied with a factory preset code (1111) which 
must be changed to a new pin code before the Wireless Keypad will 
operate. The pin code can be any 4-8 digits number except 1111.

Storing your pin code

Note: There is a timeout of approximately 5 seconds after the last button 
is pressed.

Enter 1111 followed by the hash (#) key.
Press and hold the hash (#) key again. The keypad  will beep for 
approximately 5 seconds. Once the beeping stops, release the hash 
(#) key. Enter the new pin code followed by the hash (#) key. Re-
enter the new pin code followed by the hash (#) key to con

fi

 rm. A 

short string of beeps will be produced to con

fi

 rm the acceptance of 

the new pin code.
Test operation using the new code. Enter the new code followed 
by the hash (#) key. Press  and hold any button from 1-8 and you 
should hear a continuous string of beeps.

 

NOTE: If you lose or forget a code, you will need to return the Wireless 
Keypad to B&D Doors for reprogramming. A charge will apply for this 
service.

Coding The Wireless

 

Keypad Into The Opener

Press the CODE SET button and release. The CODE SET LED will 
illuminate to indicate that the opener is in Code Learn mode. If a 
valid code is not stored within 15 seconds, the opener will exit Code 
Learn 

(Fig. 02)

.

Enter your pin code on the Wireless Keypad followed by the hash 
(#) key. Then press one of the eight (channel) buttons you wish to 
use to operate the door or gate etc. The CODE SET LED will 

fl

 ash.

Pause for a second and press the same button again on the Wireless  
Keypad. The CODE SET LED will illuminate for one second then go 
out.
Test the operation of the Wireless Keypad by entering your pin code 
followed by the hash (#) key and the stored channel button (1-8). 
The door should start to move.

Coding The Wireless Keypad Into The Tri-Tran™ receiver

Press and hold SW1/SW2 on the Tri-Tran™ receiver board 

(Fig. 

03)

.

Enter your pin code on the Wireless Keypad followed by the hash 
(#) key. Then press one of the eight (channel) buttons you wish to 
use to operate the door or gate etc.
Pause for a second and press the same button again on the Wireless  
Keypad.
Release the SW button. The Wireless Keypad code should now be 
stored into the receiver’s memory. 
Test the operation of the Wireless Keypad by entering your pin code 
followed by the hash (#) key and the stored channel button (1-8). 

a.
b.

c.

a.

b.

c.

d.

a.

b.

c.

d.

e.

Star(*) key

Hash(#) key

Fig.01

Fig.02

SW1

JP1

LED

JP2

SW2

Fig.03

Отзывы: