Nidek Medical SE-9090 Supra, Руководство по обслуживанию

Страница: 223 / 350

LLE7D*RDA002B
211
8.14.2.2 Bevel finish size adjustment
1 . Display the menu screen (see 8.1.1 [p167]) .
2 . Press [Size adjustment] on the menu
screen.
3 . Press the bevel tab to display the
Finish bevel size parameters.
4 . Press each of the following parameter
fields.
1 ) Plastic bevel
2 ) Polycarbonate bevel
3 ) Trivex bevel
5 . Adjust the finish bevel size by the procedure below.
1 ) When the measured value is more than 45.00 mm, subtract the difference from the
parameter value.
2 ) When the measured value is less than 45.00 mm, add the difference to the parameter
value.
3 ) After entering the value with the numeric keypad, press the Enter key .
4 ) Press [Exit] to return to the layout screen.
6 . Confirm the finish bevel size (see 8.14.2.1 [p210]) .
7 . Repeat adjustment until the diameter of the
processed lens is ø45 ±0.05 mm.
8 . After adjustment, perform the following.
1 ) Backing up the EEPROM data (See 8.19.1 [p284].)
2 ) Retouch check (See 8.14.2.3 [p212].)
Caution
High base curve is available in
PLB-8S only.
Select the parameter corre-
sponding to the lens material.
Adjust all parameter settings.
sPP