Nidek Medical Lex 1000, Инструкция по установке и настройке

Страница: 22 / 28

20
Wheel position (HCrvRe)
Adjustment Parameter :
Press and hold
（
STOP
）
,
then press to go to Parameter screen. Select
Parameter setting, then press . Scroll the page to Parameter setting (Page 11/12)
Wheel position (HcrvRe)
：
0.00mm
1. Call up internal 45 round. Press START. After LMU measures, in Bevel Simulation
Screen, change “TILT” value to 0.0 , then press START.
2. Check the width of top of bevel. If not 0.3mm, please adjust it to 0.3mm. If smaller
than 0.3mm or nothing, please decrease the value. If bigger than 0.3mm, please
increase the value. See the picture below.
Size Adjustment for High Curve
+
–
0.3mm
After you have adjusted Wheel position (HCrvFr) and (HcrvRe), please do size
adjustment for high curve.
Adjustment Parameter:
Press and hold
（
STOP
）
,
then press to go to Parameter screen. Select
Parameter setting, then press . Scroll the page to Finish Size (Page 1, 2/12)
CR39, HCrv
：
0.00mm
HPL, HCrv
：
0.00mm
PC/ACR, HCrv
：
0.00mm
TRX, HCrv
：
0.00mm
PUR, HCrv
：
0.00mm
GLS, Hcrv
：
0.00mm