Nidek Medical Lex 1000, Инструкция по установке и настройке

Страница: 18 / 28

16
2.7 Safety Bevel Adjustment
Before starting Safety Bevel Adjustment please set the parameters as shown below.
Front SFB size (Bevel)
：
0.3mm
Rear SFB size (Bevel)
：
0.3mm
Rear SFB size (Flat)
：
0.3mm
Rear SFB size (Flat)
：
0.3mm
Also set the SFB mode (Bevel) to F & L
SFB mode (Bevel)
：
F & R
SFB Wheel Position (Bevel)
Adjustment Parameter :
Press and hold
（
STOP
）
,
then press to go to Parameter screen. Select
Parameter setting, then press . Scroll the page to SFB (Page 8/12)
SFB wheel position
（
Bvl, Fr
） ：
0.00mm
SFB wheel position
（
Bvl, Re
） ：
0.00mm
1. Call up internal 45 circle. Use a CR39, -3D to -5D lens then grind it in Bevel Guide
(5:5) with SFB.
2. Check amount of safety bevel on both the front and the rear side. The tolerance is
+/- 0.2mm. If the amount needs to be increased, please increase the value. If it
needs to be decreased, please decrease the value.
SFB Wheel Position (Flat)
Adjustment Parameter :
Press and hold
（
STOP
）
,
then press to go to Parameter screen. Select
Parameter setting, then press . Scroll the page to SFB (Page 8/12)
SFB wheel position
（
Flt, Fr
） ：
0.00mm
SFB wheel position
（
Flt, Re
） ：
0.00mm