Nidek Medical Lex 1000, Инструкция по установке и настройке

Страница: 16 / 28

14
2.6 Groove Adjustment
Groove Depth
Adjustment Parameter :
Press and hold
（
STOP
）
,
then press to go to Parameter screen. Select
Parameter setting, then press .Scroll the page to Parameter setting (Page 9/12)
Groove Depth
：
0.00mm
1. Call up internal 45 circle. Use a CR39, -3D to -5D lens then grind lens in Nylor
Guide (Depth 0.0) mode.
2. The grooving wheel should barely touch the lens and you see a slight groove over
entire lens circumference. If too deep, please decrease the value. If no groove,
please increase the value.
Groove position
Adjustment Parameter :
Press and hold
（
STOP
）
,
then press to go to Parameter screen. Select
Parameter setting, then press .Scroll the page to Parameter setting (Page 9/12)
Groove Position
：
0.00mm
1. Call up internal 45 circle. Use a CR39, -3D to -5D lens then grind it in Nylor Guide
(Position 5:5) mode.
2. Check the position of groove to see if it is in the center (5:5). If not, please adjust it.
Decreasing the value brings the groove to the front. Increasing the value brings the
groove to the rear. See the picture below.
＋ －
＋ －