Nidec NVS-07, Инструкция по эксплуатации

Страница: 10 / 48

9
1. Close the hopper cover.
2.
Open the pressure relief valve.
3. Check that the power switch is OFF.
4. Check that the selector switch is set to STOP.
5. Check that the vacuum pump switch is OFF.
6. Check that the power cord is unplugged.
7.
Check that the auger screw fixing bolts are securely
tightened.
* Be sure to check each time before use. If the
screw becomes detached, the unit could become
damaged.
Possible unintended issues while operating:
• If the power cord and the limit switch sensor are
damaged, there is the potential danger of electric
shock and/or short circuit.
• The limit switch sensor and its cord are damaged,
as such, “the screw does not rotating” or “the auger
screw does not rotate”, regardless of opening/closing
the door.
• If the internal circuits are damaged, “the direction of
rotation could not be switched” or “the rotating speed
could not be adjusted”.
If these issues arise while operating, stop using the unit
and contact your dealer or our office.
Do not operate any switches with wet hands.
Warning
1
2
3
4
5
7
6·8
1. Supply clay.
• About 22 kg of clay can be mixed at one time. If
the amount is too small, it will take longer for the
clay to be recycled or the clay will not extrude. It is
necessary to fill the barrel to the appropriate level.
• If the clay is in large clumps, break them down to
an appropriate size first. Very wet clay cannot be
recycled by itself. To recycle really wet clay, either
dry it out some, first then recycle it or add dry clay to
the mixture.
2. Feed clay.
• Do not add too much clay into the hopper at once,
otherwise the hopper cover may not shut. Add enough
clay to see the top of the auger screw.
• While mixing, more room may be created as the
mixture compacts, After a short mixing time, add
additional clay to fill back up to the top of the auger
screw.
Make it smaller than your fist.
Feed clay to a level that allows you to view the top of the screw.
English
Preparation for use
Operation procedure