Nice WIDEL, Инструкция по использованию, установке и безопасности

Страница: 6 / 36

English –
4
The product does not contain and/or release hazardous substances in accordance with the requirements of EN 13241-1 and according to the
list of substances on the website of the European Community
Special warning to ensure the continued compliance with the requirement
– It is essential that the other materials used in the installa-
tion, such as electrical cables, comply with this requirement
• Resistance to wind load
Table B
shows the resistance of the boom to the differential pressure of the wind. The tests were performed on the barrier equipped with an im-
pact protection profile; other accessories could increase its exposed surface area and thereby reduce its resistance to wind loads.
TABLE B
Type: WIDE S WIDE M WIDE L
Class
with XBA19
with XBA15
with XBA14 + XBA15
4
-
-
4
-
-
-
3
-
-
-
2
Wind pressure [Pa]
> 1000 > 1000 > 700 > 450
Maximum wind speed [km/h] 151 151 126 101
Description Hurricane Hurricane Violent storm/gale Storm
• Safe opening for vertically moving doors
The product does not cause uncontrolled movements or allow the boom to drop in the event of failure of a single component of the suspension
or balancing (springs) system.
Special warnings to ensure continued compliance of the requirements
:
- Install the product carefully following all the instructions described in Section 3 - Installation and Section 6 - Testing and commissioning.
- Make sure there is an organised maintenance schedule that follows scrupulously the provisions in the “Maintenance Schedule” Section (re-
movable insert at the end of the manual).
• Mechanical resistance and stability
The product is designed and manufactured so that the forces, impacts and stress incurred during normal use do not cause any damage or
jeopardise its mechanical performance.
Warning : See notes to the requirement “Safe opening for vertically moving doors”.
• Operating forces for power-operated closures
The operating forces exerted by the boom with regard to the risks of crushing and impact are safeguarded against by means of one of these
three methods:
1 For operation with “hold-to-run command” (man present):
as specified in EN 12453. In this case the command button must be placed
in view of the automation and if it is accessible to the public, the command button must not be available to them, e.g. use only with a key
switch.
2 For “Semi-automatic” operation:
by limiting the forces as specified in EN 12453
3 For “automatic” operation: by limiting the forces as specified in EN 12453; in this case, at least one pair of photocells must necessarily be
installed as shown in Fig. 2.
Special warning to ensure continued compliance with the requirement : see notes to the requirement “Safe opening for vertically mov-
ing doors”.
1
PRODUCT DESCRIPTION AND INTENDED USE
WIDE is an electromechanical road barrier mechanism for residential, public and industrial use: it controls the opening and closing of a driveway
with a width from 3 to 7 metres depending on the model chosen (S - M - L).
CAUTION! – All uses other than the intended use described and use in environmental conditions other than those described in
this manual should be considered improper and forbidden!
WIDE operates with electric power and, in the event of a power failure, you can use it manually by running the manual release. It can also be
used with a back-up battery (mod. PS324 - optional accessory) which ensures performance of certain operations during power failures.
model:
INSTALLABLE ACCESSORIES
Boom Rubber Lights
Pivoting
attachment
Jointed
boom
Aluminium skirt
Mobile
support
WIDE S
3 m
R
XBA13
R
XBA4
R
WIA10
–
R
1pc - WA13
–
4 m
XBA19
R
XBA13
R
XBA4
R
WIA10
– – –
WIDE M 4 m
XBA19
R
XBA13
R
XBA4
R
WIA10
R
WIA11
R
2pcs - WA13
R
WA12
WIDE L
3 + 3 m
XBA15 + XBA9 + XBA15
R
XBA13
R
XBA6
– –
R
2pcs - WA13
R
WA12
3 + 4 m
XBA15 + XBA9 + XBA14
R
XBA13
R
XBA18 – – – –
5 m
XBA5
R
XBA13
R
XBA6 – –
R
2pcs - WA13
R
WA12