Nice TT6, Инструкции и предупреждения по установке и использованию

Страница: 6 / 120

4 - English
EN
TABLE 2 - Signalling LEDs
Led Description
DL1 Red LED Power supply indicator.
DL2 Yellow LED If on, transmitter memorisation is
active.
DL3 Green LED Signals.
DL4 12 V signal trigger indicator.
DL5, DL6 Red LED External buttons open-close in-
dicator for mechanical motor.
DL7, DL8 Red LED Open-close relays activation.
3 - Close
4 - Stop
5 - Close after 10 sec.
6 - Open after 10 sec.
7 - Close after 20 sec.
8 - Open after 20 sec.
9 - Hold-to-run close
10 - Hold-to-run open
11 - Activate the list of programmed command linked to the
12v trigger Up scenario
12 - Activate the list of programmed command linked to the
12v trigger DOWN scenario
13 - Forward radio transmission on RS232 serial
5.1 – Memorising a transmitter in “Mode I”
01. Press and hold P1 on the control unit until the green
LED DL1 lights up (after approx. 4 seconds) then
release; the yellow LED DL2 will also turn on.
02. Within 10 seconds, press and hold any key of the transmit-
ter to be memorised, until the green LED
DL1 on the con-
trol unit emits the first of 3 flashes to confirm memorisation.
Following these flashes, to memorise another transmitter in
“
Mode I ”, press any key on the new transmitter within 10
seconds. Lastly, wait until yellow LED DL2 turns off.
Caution! – When attempting to memorise a transmitter that
is already stored, the green LED DL1 will signal this by flash-
ing once.
5.2 – Memorising a transmitter in “Mode II”
01. From the “ Mode II ” list, select the function to be pro-
grammed (e.g. “Function 8”).
5 – PROGRAMMING
The control unit can memorise transmitters in two modes,
namely
Mode I and Mode II :
Mode I
– Button 1 controls the Opening for the pre-set manoeuvre
duration (Tm) (maximum 240 sec.).
– Button 2 controls the Stop.
– Button 3 controls the Closing for the pre-set manoeuvre
duration (Tm) (maximum 240 sec.).
– Button 4 controls the Stop, once again.
Mode II
The transmitter button can be linked to one of the following
functions:
1 - Step-by-step
2 - Open