Nice L9BAR, Инструкции и предупреждения по установке и использованию

Страница: 66 / 396

66 – ENGLISH
EN
ELECTRICAL CONNECTIONS
Terminals Description
OPEN Input for devices that control the opening movement only; it is possible to connect “Normally Open” contacts.
CLOSE Input for devices that control the closing movement only; it is possible to connect “Normally Open” contacts.
HP Sbs
input for devices that control the movement in the high-priority Step-by-Step mode and move the automation even
if when it is in the stalled status; it is possible to connect “Normally Open”-type contacts.
ANTENNA
input for connecting the radio receiver antenna; the antenna is incorporated in Nice LUCY B, MLB and MLBT
warning lights.
INTERNAL LIGHT
Output used to connect the LED warning light board (XBA7) or the LED traffic light board (XBA8). Moreover, the
diagnostics flashes are carried out.
It can be programmed, refer to the “ PROGRAMMING ” chapter.
LOOP1
“Normally Open” contact to connect a metal detector D1.
The operating modes associated with this input can be modified through the control unit programmer (refer to the
“ Loop detector ” paragraph).
LOOP2
“Normally Open” contact to connect a metal detector D2.
The operating modes associated with this input can be modified through the control unit programmer (refer to the
“ Loop detector ” paragraph).
MASTER-SLAVE Input for connecting two barriers in Master-Slave mode (refer to the “ Gearmotor in SLAVE mode ” paragraph).
SAFETY “Normally Closed” contact for connecting the “Pivoting boom” contact (optional accessory).
a
If the programming of the outputs is modified, check that the connected device matches the type of voltage
chosen.
FINAL CHECKS AND START-UP
5
5 FINAL CHECKS AND START-UP
5.1 BARRIER TYPE SELECTION
The controller has a set of dip-switches ( A ) in the OXI receiver
slot, allowing to identify the type of barrier. The dip-switches are
factory set: their meanings are given in the following table.
A
35
Table 5
BARRIER TYPE SELECTION
Meaning of configuration Configuration
Dip 1 Dip 2 Dip 3 Dip 4 Dip 5
Configuration not
allowed
OFF OFF OFF OFF OFF
Installation M3BAR ON OFF OFF OFF OFF
Installation M5BAR OFF ON OFF OFF OFF
Installation M7BAR OFF OFF ON OFF OFF
Installation L9BAR OFF OFF OFF ON OFF
Configuration not
allowed
OFF OFF OFF OFF OFF
5.2 CHOOSING THE DIRECTION
Choose the direction of the opening manoeuvre on the basis of
the gearmotor’s position.
Set the switching device as follows:
– set it to the RH if the spring is attached to the right-hand side
of the balancing lever (factory setting)
– set it to the LH if the spring is attached to the left-hand side of
the balancing lever
36