Nice L9BAR, Инструкции и предупреждения по установке и использованию

Страница: 59 / 396

ENGLISH – 59
EN
3.7 INSTALLING THE GEARMOTOR
a
Incorrect installation may cause serious physical
injury to the person working on the system or to its
future users.
Before starting to assemble the automation,
complete the preliminary checks described in the “
Pre-installation checks ” and “ Product usage limits ”
paragraphs.
If there is a support surface:
1. open the cubicle panel
15
2. place the cubicle on the anchoring surface and mark the
points corresponding to the slots
16
3. move the cubicle and drill the surface through the marked
points
4. insert 4 expansion bolts (not supplied)
5. arrange the cubicle properly and secure it with the
appropriate nuts and washers (not supplied).
17
If there is no support surface:
1. dig the hole to insert the foundation plate
Note The anchoring surface must be completely flat and
smooth. If the surface is made of concrete, the latter
must be at least 0,15 m thick and must be suitably
reinforced with iron cages. The concrete must have a
volume above 0.2 m
3
(a 0.25 m thickness corresponds
to 0.8 m
2
, that is, equal to a square base with sides each
measuring roughly 0.9 m). The plate can be anchored to
the concrete using the 4 expansion bolts, equipped with
12 MA screws capable of withstanding a tensile load of
at least 400 kg. If the anchoring surface is made of a
different material, it is necessary to verify its consistency
and whether the four anchoring points can withstand
a load of at least 1,000 kg. Use the 12 MA screws to
fasten the plate.
2. arrange the pipes for routing the electrical cables
3. fasten the four anchor bolts ( A ) to the foundation plate,
inserting a nut and washer (supplied) on each, on the
upper and lower sides of the plate
m
The lower nut must be screwed up to the end of the
thread.
A
B
18