Apollo 816 LA Linear Actuator
Installation Reference Manual
11
11
1.
Weld the gate bracket to the gate supporting structure (IMAGE 5-1) or use supplied 3/8” bolts and nuts
from kit (IMAGE 5-2).
2.
If welding is not possible, drill two holes to match bracket mounting holes and affix with two 3/8”x2.5”
screws and 3/8” nuts included in the kit (IMAGE 5-2).
IMAGE 5-1: GATE BRACKET WELDED TO GATE
IMAGE 5-2: GATE BRACKET AND HARDWARE (BLACK BRACKET SHOWN)
5
AFFIX GATE BRACKET TO GATE
GATE BRACKET
3/8”x2.5” HEX BOLT (x2)
WELD
3/8” NUT (x2)
IMPORTANT!
Ensure bracket centerline is 1/2” above the top of the pivot arm.
IMPORTANT!
Use a bubble level to assure after mounting that actuator is level and plumb.
CAUTION
Never weld parts to the gate or posts when the control board
is powered to avoid irrepairable damage to the circuit board!
NOTICE
Attach gate bracket
only to structural
supports. If unsure of
exact bracket location,
tack weld or clamp until
gate can be tested.
BRACKET CENTERLINE 1 INCH
ABOVE TOP OF PIVOT ARM
www.ApolloGateOpeners.com | (800) 878-7829 | [email protected]