Apollo 816 LA Linear Actuator
Installation Reference Manual
66
Fig-1B: "Push-To-Open" Pivot Arm Installation
1B
1.
Securely mount the pivot arm to the hinge post (Fig-1B).
2. If necessary, cut pivot arm for correct placement of the actuator
mounting hole. Measurements are taken from the center of pivot of
the gate hinge.
3. It is strongly recommended to weld the pivot arm to the hinge post.
INSTALL PIVOT ARM TO GATE: PUSH-TO-OPEN
TOP VIEW
6”
6”
11”
11”
PIVOT ARM
PIVOT ARM
PIVOT ARM
1/2”
HINGE POST
CENTER OF
HINGE
HINGE POST
HINGE POST
CENTER LINE OF
ATTACHMENT POINT
FOR GATE BRACKET
CENTER OF HINGE
GATE CLOSED
DIRECTION OF OPENING
LEFT SIDE VERTICAL VIEW
NOTICE
Welding is much preferred but
Nice offers an optional bolt-on
pivot arm (P/N 446) for when
welding is not possible.
CAUTION
Never weld parts to the gate or posts when the control board
is powered to avoid irrepairable damage to the circuit board!
www.ApolloGateOpeners.com | (800) 878-7829 | [email protected]
