Apollo 816 LA Linear Actuator
Installation Reference Manual
55
Fig-1A: "Pull-To-Open" Pivot Arm Installation
INSTALL PIVOT ARM TO GATE: PULL-TO-OPEN
1A
1.
Securely mount the pivot arm to the hinge post (Fig-1A).
2. If necessary, cut pivot arm for correct placement of the actuator
mounting hole. Measurements are taken from the center of pivot of the
gate hinge.
3. It is strongly recommended to weld the pivot arm to the hinge post.
SECTION 4: 816 ACTUATOR INSTALLATION
LEFT SIDE VERTICAL VIEW
TOP VIEW
6”
6”
13”
13”
PIVOT ARM
PIVOT ARM
PIVOT ARM
1/2”
HINGE POST
CENTER OF HINGE
CENTER LINE OF
ATTACHMENT POINT
FOR GATE BRACKET
CENTER OF HINGE
GATE CLOSED
DIRECTION OF OPENING
HINGE POST
HINGE POST
NOTICE
Welding is much preferred
but Nice offers an optional
bolt-on pivot arm (P/N 446)
for when welding is not
possible.
CAUTION
Never weld parts to the gate or posts when the control board
is powered to avoid irrepairable damage to the circuit board!
www.ApolloGateOpeners.com | (800) 878-7829 | [email protected]
