Nibe BA-SVM 10-200 Series, Инструкция по установке и эксплуатации

Страница: 31 / 88

31 NIBE BA-SVM 10-200
L N PE L N PE
The power supply connection is connected to termi-
nal block (X0) through the input on the back of the
unit (UB1). The power supply connection is connect-
ed to terminal block (X0) through the input on the
back of the unit (UB1).
The 230V connection allows for a maximum power of
4.5kW to the additional heating. The connection should
be made according to the diagram in the user manual.
Detailed electrical diagram - see subsection “Electri-
cal wiring diagrams”.
Connection
CAUTION
When a 230V connection is used, the maximum pow-
er of the additional heat used in the BA-SVM 10-200
unit is 4.5kW.
CAUTION
In the case of a dual tariff power supply, it is advisa-
ble to connect the neutral wire from the power supply
circuit (meter) - particularly when using a 230V con-
nection.
CAUTION
It is forbidden to install bridges at the connection of
lines L2 and L3. Otherwise, the appliance and the
electrical system may be damaged.
The manufacturer is not liable for any damage caused
by failure to comply with the above instructions.
Diagram - connecting power supply 230V
Power supply connection 230V Miniature circuit breaker
The automatic heating control system, the circulation
pump and their wiring in BA-SVM 10-200 are internal-
ly protected by miniature circuit breaker C10 (FA1).
The AMS 10 outdoor unit and accessories are inter-
nally protected in BA-SVM 10-200 by miniature circuit
breaker B20 (FA2).
X0
X0
Remove the
bridge to use dual-
-tariff control.
Insert a bridge in
order to connect the
230V power supply
IT IS FORBIDDEN TO IN-
STALL BRIDGES AT THE
CONNECTION OF LINES
L2 AND L3!
X10
X1
FD1
FA2
X0
UB1
FA1
K1A-K3A
X2
Section 6 | Electrical connections