NHRC-10 User Guide
Copyright
1999, 2000, 2001, NHRC LLC. All Rights Reserved.
Page 65
5.12.4 Select transceiver memory or VFO mode
To select Memory or VFO mode, or to select the transceiver’s current VFO, use the VFO
command:
<prefix>6<vfo-digit>
where:
<prefix>
is the remote base prefix as programmed by the repeater operator.
6
is the select VFO sub-command.
<vfo-digit>
is the VFO select digit, from the table below.
VFO-Digit Operation
0
select memory mode
1
select VFO mode.
2
select VFO A
3
select VFO B
4
make other VFO equal this VFO (A=B)
5
swap with other VFO (A/B)
5.12.5 Select a transceiver memory channel
To select a memory channel, use the following command:
<prefix>
is the remote base prefix as programmed by the repeater operator.
7
is the select memory channel sub-command.
<mem-channel>
is a 1- or 2-digit number from 0 to 99 that represents the memory
channel you want to select.
