NHRC-10 User Guide
Copyright
1999, 2000, 2001, NHRC LLC. All Rights Reserved.
Page 31
3.8.3 Program a normal autodial number
To program or say the phone number in a normal autodial slot, use the *52 command:
*52<nn><number> where:
<nn>
is the normal autodial slot number. Valid range is 00 to 99. Both
digits must be specified.
<number>
the phone number to program into that slot. 1-15 digits. Leave this
blank to inquire.
If a slot is successfully programmed, the controller will say “OK.” If the number is left
blank, then the controller will read back the autodial slot contents.
Example:
To program autodial slot #63 with 408-555-3311, send the following
command with the controller unlocked: "*52634085553311”. The controller will say
"OK" if the command is accepted.
To inquire what phone number is stored in autodial slot #63, send the following
command with the controller unlocked: "*5263”. In the case of the example above, the
controller will say "four zero eight five five five three three one one."
3.8.4 Clear a normal autodial number
To clear (delete) a normal autodial, use the *53 command:
*53<nn>
where:
<nn>
is the normal autodial slot number. Valid range is 00 to 99. Both
digits must be specified.
If a slot is successfully cleared, the controller will say “OK.”
Example:
To clear (erase) autodial slot #63, send the following command with the
controller unlocked: "*5363”. The controller will say "OK" if the command is accepted.
