21
WARNING
Because of the weight and size of the range hood,
two or more people are needed to move and safely
install the range hood. Failure to properly lift range
hood could result in damage to the product or
personal injury. Hood may have very sharp edges.
Please wear protective gloves if it is necessary to
remove any parts for installation.
PERSONAL INJURY HAZARD
DUCTED INSTALLATION METHOD (vented to the outside)
4. Locate the position the upper chimey support panel. All support
panels must be placed directly above and align with the two body
hooks. Drill two holes and insert two toggle bolts. Secure the upper
chimey support panel with two toggle bolts and screw tightly. Be
sure to use appropriate anchors for your wall. Repeat this process
for the centre chimney support panel (fig. 7).
5. If the range hood is being installed under cabinets, attach the 2
triangle panels to the rear of the hood body using four 4 mm x 8 mm
screws (fig. 4 and 5). Ensure the screw has a flat end, do not use the
sharp tipped 4 mm x 8 mm tapping screws.
6. Next, hang the hood body on the wall and tighten the screws as
shown in fig. 7. CAUTION: MAKE SURE THE RANGE HOOD IS
SECURE BEFORE RELEASING!
7. Connect the duct to the exterior exhaust system. Make sure all joints
are secure and airtight. Use duct tape to make all joints secure and
airtight (fig. 6).
8. Remove the plastic covering on the chimney extensions (duct
covers). Be very careful of sharp edges on the duct cover. Wear
protective gloves while installing duct cover to prevent personal injury
and prevent scratches on cover during installation
9. Place the chimney extensions on the floor, then lower the upper
chimney into the lower chimney. You should now have both chimney
extensions together as one unit.
10. Place the chimney onto the hood body, ensuring it fits into the gap
on the top of hood body.
11. Slide the chimney extensions upward and secure the upper chimney
to the chimney support panel using two 4 mm x 8 mm tapping
screws.
