4.10 PnP/PCI Configurations
Reset Configuration Data
Normally, you leave this field Disabled. Select Enabled to reset Extended System
Configuration Data (ESCD) when you exit Setup if you have installed a new add-on
Card and the system reconfiguration has caused such a serious conflict that the
operating system cannot boot.
The choices: Enabled, Disabled .
Resources Controlled By
The Award Plug and Play BIOS has the capacity to automatically configure all of
the boot and Plug and Play compatible devices. However, this capability means
absolutely nothing unless you are using a Plug and Play operating system such as
Windows95. If you set this field to Manual, then choose specific resources by
going into each of the submenus that follows this field.
The Choice: Auto (ESCD), Manual.
PCI/VGA Palette Snoop
Leave this field at Disabled. The Choices: Enabled, Disabled.
Figure 4-8 : BIOS -- PnP/PCI Configurations
46
Содержание PEAK 7220VL2G
