43
Parallel Port Mode
The choices available include SPP, EPP, ECP and ECP+EPP.
ECP Mode Use DMA
When the on-board parallel port is set to ECP mode, the parallel port can use DMA 3
or DMA 1.
After you have made your selections in the Integrated Peripherals setup, press the
<ESC>
key to go back to the main program screen.
4.9 Power Management Setup
Figure 4-7 : BIOS -- Power Management Setup
Auto PWR-Failure Resume
This setting specifies whether your system reboots after a power failure.
There are three selections:
Off: The system will remain off when power comes back after a power failure.
On: The system will switch on when power comes back after a power failure.
Содержание PEAK 7220VL2G
