Wake up on LAN 1
When the system enters a Soft-off mode (Standby power exists but system is not
working), it will wake up system when specific signals occurred. The BIOS monitors
the system for “activity” to determine when to enable power management.
If you enable this feature, the computer specifies that any signal noticed on the LAN
bus channel must go out from the hibernation state. The choices: Enabled, Disabled.
Power On by Ring
An input signal on the serial Ring Indicator (RI) line (in other words, an incoming call on
the modem) awakens the system from a soft off state. The choices: Enabled,
Disabled.
Reload Global Timer Events
Primary IDE 0
Primary IDE 1
Secondary IDE 0
Secondary IDE 1
The events are I/O events whose occurrence can prevent the system from entering a
power saving mode or can awaken the system from such a mode. In effect, the sys-
tem remains alert for anything which occurs to a device which is configured as
Enabled, even when the system is in a power down mode. The choices: Enabled,
Disabled.
45
Soft-Off by PWRBTN (Power Button)
Pressing the power button for more than 4 seconds forces the system to enter the
Soft-Off state when the system “hangs”. The available choices are Delay 4 Seconds,
Instant-Off
Содержание PEAK 7220VL2G
