Newwave NW 800, Инструкция по эксплуатации

Страница: 9 / 52

newwaveka.com.au
Assembling Instructions :
1. To open the lid - When the lid is closed, hold
the handle and turn in an clockwise direction
until the lid can be lifted up. See figures 1-3.
2. To close the lid - When the lid is open, hold
the handle and pull down. Once down, turn
anti-clockwise until the lid reaches the closed
position. See figures 4-6.
3.
To dismantle the lid - When the lid is
open, hold the lid with both hands and adjust
the height between the lid and the upper edge
of the cooker to around 10cm. Then, turn
anti-clockwise until the lid reaches the closed
position. See figures 7-10.
4. How to install the lid - Hold the lid with both
hands at the closed position and pull upwards
until there is around 10cm between the lid and
the upper edge of the cooker. Buckle the lid’s
sliding valve to the cooker’s slideway and turn
clockwise until you reach the opened lid position.
See figures 11-13.
5. Pressure Limiting Valve - this valve is
designed to sit loosely on the lid of your 6 in 1
Multicooker. It will rotate 360deg and will not
lock into place when placed into position. The
valve will tighten during the cooking process and
then once released will return to a loose valve
fitting.
Usage Instructions :
To open the lid - When the lid is closed, hold
the handle and turn in an clockwise direction
until the lid can be lifted up. See figures 14-15.
Adding the food - Take out the inner bowl and
place in the food and water. The amount of food
and water should not exceed 4/5 of the height
of the inner bowl. For food that will expand, the
level should not exceed 3/5 of the inner bowl.
The minimum allowable level is 1/5 of the bowl.
See figures 16-17.
Clean the outer pot - Before placing the inner
pot inside the outer bowl, make sure to wipe
clean the outer surface of the inner bowl and the
surface of the electronics heater. Once clean,
turn the inner bowl left and right inside the outer
bowl to ensure a firm contact between the inner
bowl and the Electronics heater. See figure 19.
Close the lid - Ensure the seal belt is fitted into
the inner part of the lid. Follow the assembly
instructions for details. See figures 20-21.
Adjust the Pressure Limiting Valve -Adjust to the
Airtight position and ensure that the floater sinks.
See figures 22a - 23b.
Turn on the power supply - Once the power
is turned on, the LED Screen will display “0000”.
The first red digit indicates the time of the Preset
Timer, while the first two red digits show the self
selected Pressurized Cooking Time.
Configure the parameters and Start the
heating process -
Set the Preset Time. Press
Timer once to increase the timer by one hour.
The maximum preset timer period is 9.5 hours.
After 9.5 hours, the timer will start a new cycle
again.
Assembling Instructions