New Rock Technologies MX100-AG, Руководство по установке, Страница: 7 / 23

Shanghai New Rock Technologies, Inc. Page 7/23
1
Installation Preparation
1.1
Installation Preparations
1.1.1
Collecting the Technical Documents
The technical documents, include network diagram, equipment room facility plan, installation design
drawings, wiring drawings, etc, should be provided by the party who is responsible for preparing the
documents under the request of purchasing party. Copies of the documents should be provided by the
purchasing party to the gateway supplier prior to the shipment.
This manual and < Operation Manual for MX Gateway Series > should be provided to the purchase
party in the shipment.
A <Site Survey Report> must be completed prior to the installation. When all required conditions are
satisfied, <Installation Project Agreement> should then be prepared and signed-off, and <Installation
Project Plan> should be prepared.
1.1.2
Tools and Meters
The tools and meters listed in table 1-1 are required for the installation.
Table 1-1 Tools and Meters for the Project
Items
Philips Screwdriver
Slotted Screwdrivers
Diagonal Cutter
RJ45 & RJ11 Crimping Tool
Wire Stripper
RJ45/RJ11 Cable Tester
Angle Square
Spirit Level
Multimeter
Antistatic wrist strap
Cable Tie
Gloves
Antistatic Gloves
1.2
Site Requirements
1.2.1
Temperature and Humidity
Check the temperature and humidity of equipment room. To ensure the normal operation and long
service life of the gateway, the temperature and humidity in the room should be kept at the proper
range.
The humidity in the equipment room should be kept between 10% and 90% (non-condensing).
Abnormal humidity condition may cause problems to the gateway:
z
Long term high humidity may lead to bad insulation and even cause electricity leakage,
mechanical property change and corrosion.
z
Low humidity is likely to leave captive screws to loose due to static electricity built up and the
insulation washer shrunk.