KH 150 AES67 |
24
Saving the current settings as default
In order to save the current configuration to the start-up configuration:
X
Navigate to the
AES67 CONFIG
menu item .
X
Click
Save Active Configuration
.
Rebooting the loudspeaker after setting the IP addresses and redundancy mode
After setting the IP addresses and the redundancy mode, the loudspeaker needs to be rebooted
before performing any further configuration .
X
Navigate to the
AES67 CONFIG
menu item .
X
Click
Reboot Device
.
After the reboot, the settings configured as mentioned above will become valid . You
might need to adjust the IP settings of your PC/Mac according to the new primary
addresses in order to access the web interface .
Setting up the PTP media clock
After the initial setup of the AES67 interface and rebooting the loudspeaker, you can set up the
PTP media clock .
Setting up the PTP media clock synchronization
To set up the PTP media clock:
X
Open the web interface of the KH 750 AES67 .
X
Navigate to the
AES67 SYNC
menu item in the menu on the left .
X
Set up the PTP sync according to your system settings .
The available predefined PTP profiles are:
AES67:Media Profile
PTP profile for AES67 audio-only networks
IEEE1588v2:Default
PTP profile used for time-sensitive networks such as
streaming applications
SMPTE:2059-2
PTP profile for ST 2110 video and audio networks
We recommend using the AES67:Media Profile (factory default) for audio-only networks .
EN
