KH 150 AES67 |
22
To access the loudspeaker’s web interface for the first time:
X
Connect the loudspeaker directly to your PC/Mac via the PRIMARY network socket .
For the initial access no network switch is required and the SECONDARY network socket
needs to be unconnected .
X
Make sure that the loudspeaker is switched on .
X
Set the IP address of your PC/Mac to an IP address in the following ranges:
• 192 .168 .0 .0 to 192 .168 .0 .99
or
• 192 .168 .0 .101 to 192 .168 .0 .255
X
Set the subnet mask of your PC/Mac to 255 .255 .255 .0
X
Open a web browser (Google Chrome is recommended) and enter the default IP address of
the loudspeaker in the address line of the browser: 192 .168 .0 .100
The home page of the web interface will open and display information about the connected
loudspeaker .
After initially adjusting the IP addresses and rebooting the loudspeaker, you might need
to re-adjust the IP settings of your PC/Mac according to the new primary addresses in
order to access the web interface for future configuration .
Setting up IP addresses and network redundancy
Depending on the mode you will be using (redundant/non-redundant) and your existing net-
work configuration you can change the IP addresses of the loudspeaker according to your
requirements .
The first three necessary steps in the initial configuration are
• setting the IP addresses
• setting the redundancy mode
• saving the settings as default
After that the loudspeaker needs to be rebooted in order to perform any further configuration .
To change the
IP addresses
:
X
In the web interface, navigate to the
AES67 IP CONFIG
menu item in the menu on the left .
The IP address configuration screen will be displayed .
To set up
IP addresses
for
non-redundant
operation (switched mode):
X
Click on the first line (eth0) of the IP address page .
EN
