NTI Secure Remote Power Reboot Switch
89
Cascade Notification
In the event a slave goes offline from the system, the system can be set to notify those configured to receive messages from the
master unit. Selecting 5 from the “Cascade Configuration” menu will open the “Cascade Notification” menu where you can specify
how frequent notifications will be repeated. Cascade Notification cannot be disabled.
Figure 109- Text Menu-Cascade Notification Settings
An example of the notification you will receive is:
11-12-2010 11:18:38 AM
Sensor Not Responding
--
Slave Unit #2 (
Unit Name
) not
responding
Suggestion: To avoid receiving unnecessary notifications, don’t enable the slave (Figure 106 and Figure 108) when
configuring the master until the slave has been fully configured first.
The default time period in which notifications will repeat is every 30 seconds.
To change the value
:
1. While the number value is selected, press the <
Delete
> key to remove the value and type the desired value (range is 1-99).
Press <
Enter
> to move to the units value.
2. Press an arrow key to toggle between seconds (Sec), minutes (Min), or hours (Hr). Press <
Enter
> again to move to “Save”.
3. Press <
Enter
> again to save the change, or press <
Tab
> to return to the number value.
Figure 110- Cascade Notification Configuration
