NTI Secure Remote Power Reboot Switch
87
RS485 Master
If the type is
RS485 Master
, then the RS485 addresses for each slave (valid address range of 1-255) must be entered into the
available slots (up to 16) in order to communicate between the master and each slave. The RS485 unit address and Slave IP
address settings will not apply to this configuration. To configure a slave to be connected, select the desired slave number and
press <Enter> to open the “Edit Slave Address” menu.
Figure 105- Text Menu- RS485 Master's slave list
In the “Edit Slave Address” menu, the slave can be either enabled (set to establish communication with the slave) or left disabled.
If set to enable, be sure to enter a valid unique RS485 address (valid number range is 1-255).
Note: Address values entered outside the valid number range will be accepted by the master, but ignored.
Figure 106- Text Menu- Edit RS485 Slave Address