NTI Secure Remote Power Reboot Switch
5
INSTALLATION
Connect AC Power Cables
The IPDU-Sx may be connected to a 100-240VAC power supply. A 120V power cord with NEMA 5-15 connector is provided for
connection to a power supply. The AC outlets (“AC OUT 1” and “AC OUT 2”) are rated for up to 10A @ 120/240VAC and the
combined maximum load cannot exceed 10A for IPDU-S2, IPDU-S4/S8-P10, or 15A for IPDU-S4/S8-P15.
Figure 1- Connect power cords
Ethernet Connection
Connect a CAT5 patch cable (RJ45 connectors on each end wired pin 1 to pin 1, pin 2 to pin 2 etc) from the local Ethernet
network connection to the connector on the IPDU-Sx marked "ETHERNET".
Figure 2- Connect IPDU-S2 to the Ethernet
Note: A direct Ethernet connection can be made with a PC using a crossover cable. For the pinout of this cable, see
page
108.
Power
1
2
Outlet
Fault
Sensor
IP
Reset
RJ45 Sensors
Console
Ethernet
NTI
R
Network Technologies Inc
ENVIROMUX
R
Fault
RJ45 male
connector
Ethernet