4
Sleeping Mode
The device is on and in the
network
Sleeping period: Min Interval.
When the reportchange exceeds setting value or the state changes: send a data report according to Min Interval.
The device is on but not in
the network
First two mins: wake up every 15 seconds to send request.
After two mins: enter sleeping mode and wake up every 15 minutes to send request.
Note: Suggest to remove batteries if the device is not used.
Suggest to check device verification on gateway.
Low Voltage Warning
Low Voltage
3.2 V
5. Data Report
When the device is powered up, it will immediately send a version package and a data report package of temperature, illumination, infrared status and
voltage.
Data will be reported once every hour by default setting.
Maximum time: Max Interval
Minimum time: Min Interval (default current ambient temperature, illuminance value, voltage value are checked per Min Interval)
Default reportchange: Battery - 0x01 (0.1V)
Temperature----0x0064 (1°C)
Illumination----0x0064 (100Lux)
Infrared trigger:
After the RB11E device detects the infrared, the red LED blinks once, and immediately reports the status values of all the current sensors.
Infrared status bits: Someone: "1"; No one: "0"
Note:
The data transmission cycle of the device is subject to the programming configuration before shipment.
The interval between two reports must be the minimum time
RB11E default Max Interval = 1hour, Min Interval = 1hour
(if there is special custom configuration, the setting will be changed according to customer requirements)
The data reported by the device is resolved by the Netvox LoraWAN Application Command document.
Or refer to http://www.netvox.com.cn:8888/page/index
Min Interval
(Unit:second)
Max Interval
(Unit:second)
Reportable Change
Current
Change≥
Reportable
Change
Current
Change
＜
Reportable Change
Any number between
1~65535
Any number between
1~65535
Can not be 0
Report
per Min Interval
Report
per Max Interval
