7
Example1:
The IRDetectionTime is 60 seconds and the IRDisableTime is 30 seconds, no living creature is detected during the two 9-second detection period (the
yellow parts shown below).
RB11E will report “unoccupied” after 60 secs(IRDetectTime).
Example2:
The IRDetectionTime is 60 seconds and IRDisableTime is 30 seconds, living creature is detected at the 25th second of the first 30 seconds.
RB11E will restart the IR detecting procedure(IRDetectionTime).
No living creature is detected during the next IRDetectionTime and RB11E therefore report “unoccupied.”
7. Installation
7.1 Tips for installing the double-sided stickers
1. Clean the surface of the objects you plan to use the sticker with.
2. Tear off one side of the sticker, place it to the bottom of the product as shown on the picture, and
press it.
3. Tear off the other side of the sticker and put the sticker to a clean surface of the wall (the direction
of arrow shows up ) and press the sticker firmly for around 20 seconds.
Note
：
1. The white release paper side (with gray letters 3M9080A) is for the wall.
The brown release paper side (with green letters 3M300LSE) is for the plastic base of the product.
2. Make sure there is no dust on the surface of the wall: wipe the dust and dirt off the wall.
3. Make sure the wall is not wet: it is recommended to use a dryer to dry the wall before putting the
sticker.
7.2 Tips for installing the steel nails
1. Make sure there is no dust on the surface of the wall.
2. Dispart the bottom of the product, as shown on picture 1.
3. Put the steel nails through the holes of the bottom part, place the bottom with the nails on where you want to install the device on the wall, and drive
the nails into the wall. Leave 2mm of the nails from the surface of the bottom part, as shown on picture 2.
4. Fasten the rest of the device to the bottom, as shown on picture 3.
Picture 1
Picture 2
Picture 3
