WG102-500, WGAP150 ProSafe 802.11g Wireless Access Point Reference Manual
Management
3-11
v1.0, February 2009
The VLAN ID to be set on a client session is passed on from the Radius server in a vendor
attribute in the Access-Accept response called Tunnel-Private-Group-ID. When the
Tunnel-Private-Group-ID attribute is present, the default VLAN ID setting will be overwritten
with the value of the attribute.
Restoration of Factory Defaults
The following procedure restores the settings of the wireless access point to factory defaults:
1.
Power on the unit, and wait for 1 minute until the Status LED turns green.
2.
Press and hold the reset button on the rear panel (see
) for at least 5 seconds, then
release the reset button.
3.
The Status LED will blink, and then the unit will automatically reboot.
4.
Wait for 1 minute or until the Status LED turns green, upon which the settings of the wireless
access point will have been restored to the factory defaults.
By default, the unit will acquire an IP address from a DHCP server.
Figure 3-7
Figure 3-8
FullManual.book Page 11 Thursday, January 29, 2009 10:12 AM
