NETGEAR ProSafe WG102-500, Справочное руководство

Страница: 11 / 52

WG102-500, WGAP150 ProSafe 802.11g Wireless Access Point Reference Manual
Introduction and Installation 1-3
v1.0, February 2009
The following figure shows a rear panel view of the WG102-500, WGAP150:
Viewed from left to right, the rear panel of the WG102-500, WGAP150 provides the following:
1. Antenna . An RP-SMA connector for connecting the antenna.
2. LAN Connector . A 10/100BaseT Ethernet connector, normally to be connected to a back haul
network.
3. Reset Button . A reset button to be depressed with a pin. Depress and hold for at lease
5 seconds to restore factory defaults. (For more information, see “Restoration of Factory
Defaults” on page 3-11 .)
4. Power Connector . A connector for 5 VDC power input, to be connected with the supplied
power adaptor.
Viewed from left to right, the WG102-500, WGAP150 has these four status LEDs: Power, Status,
Ethernet, and Wi-Fi (also referred to as WLAN light or Wireless activity light):
Figure 1-2
Table 1-1. Rear Panel LEDs
LED Description
Power Off – Power off
On (Green) – Power on
Status Off – The unit is initializing.
Green – The unit is ready.
LAN Off – The Ethernet port is not connected.
On – The Ethernet port is connected.
Wi-Fi Off – Wireless is not ready.
On – Wireless is ready.
FullManual.book Page 3 Thursday, January 29, 2009 10:12 AM