Neptune Technology R450, Руководство по установке и обслуживанию

Страница: 52 / 144

2. Check to see if the red TX light at the bottom of the Midland
Radio is flashing every 10 seconds. Refer to Figure 67 on page 62.
l
If red
TX
light is not flashing every 10 seconds, call Neptune
Customer Support. Refer to "Contacting Customer Support" on
page 69.
l
If the red TX light at the bottom of the Midland Radio is
flashing every 10 seconds and you do not receive readings,
there is either a problem with the network connection or a
problem with the N_SIGHT PLUS host software.
l
Check that N_SIGHT PLUS host software is configured to send
emails to the correct email address.
l
Check the host software to ensure that the R450 DC is
synchronizing.
If you have a GPRS modem, proceed to the next section,
"Manually Configuring the GPRS Modem". If you have an Ethernet
connection, consult with your utility network IT group.
Your GPRS service provider will need to manually set up the
GPRS modem. To manually set up an account, your service
provider will require the necessary information: username,
password, and APN (Access Point Name). Refer to the setup
guide included with the modem.
Manually Configuring the GPRS Modem
To manually configure the GPRS modem, you must have the required
equipment prior to completing the steps for configuration.
Required Equipment
The following equipment is needed to configure the GPRS modem.
l
Laptop or PC with Ethernet network
l
Modem Quick Start Guide
l
Ethernet cable
l
GPRS service provider, APN, and password (supplied by the service
provider
l
Nutdriver, 3/16 inch (Wiha P/N 265) or consult
www.wihatools.com
32 R450 Data Collector Installation and Maintenance Guide
Chapter 3: Installation of the R450 DC