v1.01 TDC-HB 11-5-2009
page 1 of 4
OBSERVATOR
instruments
Quick Start Guide
OMC-045-II
Introduction.
This manual is intended as a guide how to quickly setup your OMC-045-datalogger with OMC-
Programmer. For more detailed information we refer to the
help files
, which you can access via
the [F1] function key anywhere in OMC-programmer.
1. Check required items:
-
OMC-045-II
-
SD-card
(included)
-
USB cable (included)
-
GSM/GPRS antenna (included)
-
SIM card
-
Optional GPS antenna
-
OMC-Programmer
-
Suitable sensors
-
Suitable power supply
Important notes:
SD-Card:
The included SD card is specially formatted for the OMC-045-II
DO NOT FORMAT THE CARD VIA WINDOWS!
Leave the switch to the ‘LOCK’ (= Write Protect) position whenever
used in a pc.
SIM card:
Check the card in a phone, make sure the PIN code is disabled.
Test if GPRS is available.
BOTH CARDS SHOULD ONLY BE PLACED OR REMOVED WHEN THE POWER IS OFF!
Power Supply:
If the sensors are powered via the OMC-045-II, make sure the PSU
(
P
ower
S
upply
U
nit) is suitable for both the OMC-045-II and the sensors.
Else the sensor should be powered by a separate PSU.
The output voltage of the OMC-045-II is identical to the PSU!
2. Connect all sensors & antenna’s
-
Use delivered diagram or use the connectors layout in the appendix to determine the
correct connections.
-
Connect the power supply
-
Do not connect the OMC-045-II by USB before you installed OMC-programmer
3. Install OMC-programmer
-
Check the support page of
www.observator.com
(Obsermet Meteo & Hydro)
for the
latest version.
-
Install OMC-programmer on your pc, this will also install the required USB driver
