NeoRe 11 TG TX, Руководство по установке

Страница: 25 / 52

� . Commissioning
� . � Commissioning of the heating system
Before starting the heat pump, it is necessary to water the circuit. It is � lled with water up to a base pressure of � - � . �
bar. Depending on the height of the water column of the heating system, the base pressure increases by � . � bar per meter
of height. Then the circuit must be completely deareated. Venting the indoor unit is carried out on the upper right side of
the plate heat exchanger. After the circulation pump is started, the plate heat exchanger must be completely vented, which
is signalled by settling down of the circulation pump running. Before starting the compressor, it is recommended to run the
circulation pump for at least �� minutes.
More in Installation manual chapter Connection of the heat pump to the heating system .
� . � Startup
After watering and venting, the electrical equipment of the heat pump can be tested.
Turn on the "Technology" circuit breaker and press the On button in the "Overview" section after initializing the controller
system. This will turn the circulation pump on. Check the condition of the hydraulic system. If the � ow and pressure are OK,
you can turn on the remaining circuit breakers. Check the settings and check the operation of all heat pump technologies,
especially the outdoor unit (see User manual, DHW chapter ?? on page ?? ).
• BIVALENT - breakers of the bivalent source
• OUTDOOR UNIT - breakers of the outdoor unit supply
• TECHNOLOGY - breakers of indoor unit technology (regulation, � -way valve, circulation pump...)
• DHW HEATING - protection of DHW heating technology
Figure � . � : Heat pump safety elements
��