Stud welding unit N1500i
As of: Aug 12.2021
Manual part number: BE 1221
42
Tucker GmbH,
Mail / Post:
Max-Eyth-Str.1, 35394 Gießen, Germany
4.6 Additional Cautions
SELECT SUITABLE LOCATION
The N1500i will operate in harsh environments. Even so, it is important that simple
preventative measures are followed in order to assure long life and reliable operation.
The machine must be located where there is free circulation of clean air such that air
movement in the back, out the sides and bottom will not be restricted.
Dirt and dust that can be drawn into the machine should be kept to a minimum.
Failure to observe these precautions can result in excessive operating temperatures
and nuisance shutdown.
Keep machine dry. Shelter from rain and snow. Do not place on wet ground or in
puddles.
Caution!
DO NOT MOUNT OVER COMBUSTUBLE SURFACES.
Where there is a combustible surface directly under stationary or fixed
electrical equipment, that surface shall be covered with a steel plate
at least 1.6mm thick, which shall extend not less than 150mm beyond
the equipment on all sides.
STACKING
•
N1500i cannot be stacked.
TILTING
•
Place the machine directly on a secure, level surface or on a recommended
undercarriage. The machine may topple over if this procedure is not followed.
INPUT AND GROUNDING CONNECTIONS
•
Only a qualified electrician should connect the N1500i. Installation should be
made in accordance with the appropriate Natio- nal Electrical Code, all local
codes and the information detailed below.
•
When received directly from the factory, 230/460V machines are internally
