4 NED
XCM4040SAT4 UME-0002-04
Instructions before use
Only operate this product within the recommended environmental
temperature range.
Use only the specified power source and voltage rating.
Do not drop this product. Avoid exposure to strong impact and vibrations.
Install the camera unit in a well-ventilated environment, in order to prevent
the camera from overheating.
If the camera must be installed in an environment containing dust or other
particles, take required measures to protect the camera unit from dust
adhesion.
Do not unplug the cable while power is being supplied to the camera unit. To
prevent product damage, always shut down the power supply before
unplugging the power cable.
When the surface of the camera window becomes dirty due to dust or grime,
black smudges appear in the displayed image. Use an air blower to remove
the dust particles. Dip a cotton swab into ethanol alcohol and clean the
camera window. Be careful not to scratch the glass.
Use of non-infrared lighting such as a fluorescent lamp is recommended. If
halogen lighting is employed, always install an infrared filter into your system
configuration.
Please note that exposure to long wavelength light outside of the sensors
visible optical range can affect the image.
Sensitivity may fluctuate depending on the spectral response level of the
light source. In cases like this, changing the light source to one with a
different spectral response level may reduce this problem. Moreover, this
irregular sensitivity can be completely lost by using 4.11 pixel correction
function. Please refer to 4.11 pixel correction function for details.
For stabilized image capturing, turn ON the power supply and execute aging
for ten to twenty minutes before actually using the camera unit.
Do not share the power supply with motor units or other devices that
generate noise interference.
Do not disconnect the camera while rewriting an embedded memory.
When you change exposure mode that is set at NED factory, input control
signal (CC1) from the capture board.
