NEC SVP SERVER -, Инструкция по установке и настройке

Страница: 43 / 56

5-1
SVP Server Installation, Setup, & Maintenance Manual - Revision 1
5
Swapping/Adding/Deleting SVP
Servers
This chapter describes how to swap, add, and delete SVP Servers.
Chapter Topics
• IP System
• UNIVERGE WL System Telephony Gateway
IP System
Whenever a SVP Server is removed from the system, Wireless
Telephones that are using the SVP Server will be affected. If the
removal of the SVP Server is intentional, the administrator should lock
and idle the system prior to removing a SVP Server.
Whenever a SVP Server is added to the system, the change is
seamless and does not affect Wireless Telephone calling functionality.
Adding a SVP Server
In the IP PBX environment, a new SVP Server is detected within two
seconds of being added to the system (booted/configured/connected).
When detected, any Wireless Telephone not active in a call will
immediately be forced to check-out and check-in again. Any Wireless
Telephone in a call will immediately switch to the SVP Server that
should provide its “timing” function. This switch should not be
noticeable to the user since it is similar to a normal handoff between
access points. When the Wireless Telephone ends the call, it will be
forced to checkout and checkin again.
Removing a SVP Server
When a SVP Server is removed from the system it is detected within
two seconds. Wireless Telephones not in calls are immediately forced to
checkout and checkin again.