5
Attention to Installing, Moving, Storing, Connection
Do not close the ventilation hole.
Do not close the ventilation hole in the front side of the Built-in LTO. Otherwise, its
internal temperature will rise to cause malfunctions or a fire.
Do not connect/disconnect the interface cables before unplugging the power
plug.
Before connecting/disconnecting the interface cables, disconnect the power plug of
the main power unit from the outlet. If the power is off but the power plug is still
connected, you may get an electric shock.
Do not use the unspecified interface cables.
Uses only the cable authorized by NEC and locate the device and connector before
connection. Use of an unauthorized cable or displaced connection may cause a
short circuit, resulting in a fire.
When handling or connecting the interface cables, keep the notes as follows:
Do not tread on cables.
Do not load on the cable.
Insert the cable connector as far as it goes.
Do not use damaged cables.
Do not use damaged connectors.
Make sure that screwing or the like is done firmly.
Do not use or keep in the environment where corrosive gas exists.
Do not use Built-in LTO Auto Loader, installing in the environment where corrosive
gas (sulfur dioxide, hydrogen sulfide, nitrogen dioxide, chlorine, ammonia, ozone,
etc.) exists.
In addition, do not set it up in the environment including the element (sodium
chloride and sulfur, etc.) that promotes corrosion in dust and air, and the
electro-conductive metal etc. The print plate in the device corrodes, and it might
cause the breakdown and smoking and the ignition.
When there is the above-mentioned doubt in the environment of use, please consult
with a store or a maintenance service company.
Avoid installation in extreme temperature condition.
Immediately after the power supply of the server is turned off, components in the
server including the internal hard disk drive or others are hot. Please install/detach
the device after confirming it is cold enough.
