23
Ejecting the Data Cartridge
1.
Ensure that the Built-in LTO is powered-on.
2.
Press the eject button. The drive rewinds the tape and partially ejects the
cartridge. The eject cycle will take a few minute.
If the cartridge eject command is issued by the backup software, the Built-in LTO
rewinds the tape, but does not eject a cartridge. In this case, make sure that the LTO is
ready to eject a cartridge (the status LED blinks twice and repeats that cycle). Then,
press the Eject button to eject a cartridge.
3.
After the cartridge partially ejects, grasp the cartridge and remove it.
When the status LED is blinking, do not turn off the server. This may cause a
malfunction or damage data.
To avoid a malfunction, do not transport this drive with the data cartridge installed.
Eject the data cartridge upon completion of backup process.
