NEC Mobile Suite User Guide for N411i
Rev 1.0 6/May/2005
Below is a sample of the Comms Service menu that the user can easily access by right clicking on it.
The first line,
XXXX connected on COMx
, indicates which is the phone model (
XXXX
) and in
which PORT (
COMx
) it was detected. If no phone is connected the text “
No phone
connected”
will be displayed.
The second, third and fourth line,
Personal Information Manager
,
Multimedia Resource
Manager
and
Backup/Restore,
allow the user to start these applications within the NEC
Mobile Suite (they can be loaded at the same time).
Phone selection
loads the screen with the same name already discussed above.
Configure COM port
enables the user to set manually the COM port used to communicate
with the Phone. By default all existing COM ports are listed. When the user connects a phone
using a USB port, this last is added to the list. The list is only updated when the user accesses
it.
About
brings up a screen where the user can verify the software version of each NEC Mobile
Suite module (PIM & MRM), the Comms Service and the NEC Mobile Suite itself.
Exit
closes the Comms Service, along with the NEC Mobile Suite if it’s opened.
The systray icon can assume 5 status forms:
No phone connected
Phone connected
Auto detecting phone
Data transfer in progress
Manual port changed. It’s not yet confirmed if the selected port is valid.
Each of these status forms will be discussed later.
