NEC Mobile Suite User Guide for N411i
Rev 1.0 6/May/2005
[delete all] –
deletes all contacts from the selected group.
[apply]
to confirm the changes
[cancel]
to resume the previous settings
The button below is only available in Modules Notepad and Bookmark (
notice that this module is not
available on all phone models
):
[New Folder]
adds a new folder in the Notepad or Bookmark
4.3.3.2
Contacts
The
Contacts
has three main areas:
Groups
are on the left
Contacts
are in the middle
Details
of the selected contact are on the right
The names stated above will be used each time one of these areas is referred.
4.3.3.2.1 Groups area
In this area the user can find an All Groups indicator, a No Group one and all 19 predefined groups.
Each one of these (when pressed) acts as a filter so the user can view the corresponding contacts on
the
Contacts
area. When selected they will act as follows:
All Groups
- Show the user, on the
Contacts
area, all contacts available, including those that
are in No Groups.
No Groups
- all contacts that have no defined group will be shown.
When a particular group is selected the corresponding contacts are shown.
The All Groups and the No Group names can’t be changed, but the groups can at any time be
renamed. For that the user has to select the target group, then click on it again or press
<Enter>
. The
user can cancel the changes at any time by pressing
<Esc>
.
On the bottom of the
Groups
area is the
Group Default Settings
area. In here the user can change
three fields for each group, which are Melody, Picture and Led colour.
Melody
corresponds to the melody that is going to be played each time a call is received by a
particular contact, or contact belonging to a group (that has this melody defined).
Picture
is the one being displayed in the same conditions as Melody.
Led
colour is the colour displayed by the phone led, again in the previously mentioned
conditions.
Each one can be set for a particular group and in doing so all contacts (of that group) will be affected in
the following way:
- All contacts will assume the default settings for the fields that aren’t set already.
