2. BIOS Setup Utility (SETUP)
Express5800/R120g-2E User's Guide
158
Chapter 3 Setup
2.
BIOS Setup Utility (SETUP)
This section describes how to configure Basic Input Output System (BIOS).
Make sure you have read and understood this section to configure properly.
2.1
Overview
BIOS Setup Utility (SETUP) is a utility to do basic hardware settings. This utility is installed in a flash memory in
the server as standard and can be run without requiring a media for boot.
BIOS settings were configured with optimal settings before the server was shipped to you. Therefore, in most of
cases, you should not need to use the SETUP.
Use only when the case applies to any of cases described in
Chapter 3 (2.4
Cases that Require Configuration
)
.
2.2
Starting SETUP Utility
Run POST following
Chapter 3 (1.1.1
POST sequence
).
After a while, the following message will be displayed on the lower left of the screen. (The on-screen message
depends on your environment.)
Press <F2> SETUP, <F3> Internal Flash Memory, <F4> ROM Utility, <F12> Network
If you press the <F2> key, SETUP starts upon completion of POST, and the
Main
menu is displayed.
Tips
In Legacy boot mode, you can also launch SETUP by pressing the <F2> key while
expanding option ROM.
Password
If you have set a password, a message prompt you to enter password will be displayed.
Enter password
[ ]
You can attempt password entry up to 3 times. If you entered an incorrect password 3 times, operation stops.
(You cannot operate further.) Turn off the power.
Saving changes
If you finish configuration, select
Save & Exit
and then
Save Changes and Exit
to save changes and exit.
If you wish to exit without saving the changed parameters, select
Save & Exit
and then
Discard Changes
and Exit
.
Tips
•
If you wish to restore the setting to default values, select
Save & Exit
and then
Load
Setup Defaults
.
•
The default value might be different from the factory setting.
•
You cannot restore the default value in the following submenus in
Advanced
menu:
–
iSCSI Configuration
submenu
–
UEFI Driver Configuration
submenu
