NEC Express5800/T120a-E N8100-1531F, Руководство пользователя, Страница: 315 / 542

Troubleshooting 8-25
POST fails to complete:
‰
Is the DIMM board installed?
→
Check the installation location of DIMMs (see Chapter 9).
‰
Is the memory size large?
→
The memory check may take a few seconds if the memory size is large. Wait for a
while.
‰
Did you perform any keyboard or mouse operation immediately after you started the
server?
→
If you perform any keyboard or mouse operation immediately after start-up, POST
may accidentally detect a keyboard controller error and stops proceeding. In such
a case, restart the server once again. Do not perform any keyboard or mouse
operation until the BIOS start-up message appears when you restart the server.
‰
Does the server have contains appropriate memory boards or PCI devices?
→
Operation of the server with unauthorized devices is not guaranteed.
Fail to access to internal or external devices (or such devices fail to operate):
‰
Are cables properly connected?
→
Make sure that the interface cables and power cord are properly connected. Also
make sure that the cables are connected in the correct order.
‰
Is the power-on order correct?
→
When the server has any external devices connected, power on the external
devices first, then the server.
‰
Did you install drivers for connected optional devices?
→
Some optional devices require specific device drivers. Refer to the manual that
comes with the device to install its driver.
‰
Is BIOS configuration correct?
→
Some devices connected to the serial or parallel port may require I/O port address
or operation mode settings. Refer to the manual that comes with the board for
details to make correct settings.