NEC Express5800/120Re, Руководство пользователя

Страница: 288 / 346

9-34 Upgrading Your Server
Notes
Observe the following notes on installing/removing a PCI board:
„
Do not touch the terminals of the riser cards and the leads of electronic components with
your bare hand. Fingerprints and dust left on them cause the server to malfunction due to a
connection failure or damage to the leads.
„
A riser card is designed for installing only low-profile PCI boards or full-height PCI
boards. Before installing a PCI board, make sure of the card specification.
„
PCI slot number "1C" is assigned to the riser card for low-profile PCI boards, and "1B" is
assigned to the riser card for full-height PCI boards.
„
The system detects the boot devices in order of the PCI bus slots 1C (low-profile PCI
board) and then 1B (full-height PCI board).
„
The PCI devices of the same type (including onboard PCI device) may be recognized in
different order from that described above, depending on OS or disk array BIOS utility.
Check the slot location of PCI device by PCI bus number, device number and function
number shown in the table below.
Bus number Device number Function number
Onboard NIC1 2 1 0
Onboard NIC2 2 1 1
Slot 1C 2 2 X
Onboard SCSI Ch A (external) 2 3 0
Onboard SCSI Ch B (internal) 2 3 1
Slot 1B 3 * 7 X
* The bus number may be 5 or greater depending on the board installed in Slot 1B.
„
Set "Disabled" for the optional ROM of a LAN device not to be booted by using the BIOS
SETUP utility.
„
If an additional LAN device is installed, it is hard to push the catch of the connector with
your finger that is connected to the LAN port. Disconnect the connector pushing the catch
with a standard screwdriver. At this time, be very careful for the screwdriver not to
damage the LAN port or other ports.
„
If a bootable PCI board (e.g., a disk array controller, SCSI controller, or LAN card) is
additionally installed, the boot priority is changed. After the additional installation, start
the BIOS SETUP utility, select [Boot] and set the new boot priority.
„
Contact your service representative for the acceptable optional PCI board.