NEC Express5800/120Re, Руководство пользователя

Страница: 163 / 346

Installing the Operating System with Express Setup 5-27
Installing the Windows 2000
This section describes on how to setup the system using Express Setup.
Prepare Configuration Diskette. You can operate the installation if you do not have Configuration
Diskette specified in advance, but one floppy disk formatted by MS-DOS 1.44MB is necessary also
in such case. For Configuration Diskette, use the blank disk in NEC EXPRESSBUILDER
package or prepare other floppy disk personally.
IMPORTANT:
„
If you modified the system configuration, execute "System
Update".
„
If you want to modify or add Graphics Accelerator Driver or the
drivers of Network Adapter and so on, see Appendix D.
1.
Turn the power of peripheral device on, and then turn on the server.
NOTES:
„
If you operate installing Windows 2000 with MO device connected,
the installation may not be completed normally. In such case,
detach MO device and then re-install the system from the
beginning.
„
Connect the hard disk that OS is not going to be installed after
installing OS.
„
If you create multiple logical drives in your system, refer to "Re-
installing the operation system when multiple logical drives exist"
(Appendix E).
2.
Insert NEC EXPRESSBUILDER CD-ROM into the CD-ROM drive of the server.
3.
Ensure that the floppy disk drive is empty.
4.
Press the RESET switch or press
Ctrl
,
Alt
, and
Delete
to reboot from the NEC
EXPRESSBUILDER. (You may also turn off and then on again to reboot the server.)
The system will boot from the CD-ROM and NEC EXPRESSBUILDER starts.
5.
Click [Express Setup].
"Note" will be displayed.
6.
Read the instruction carefully and click [OK].
The message "Insert Configuration Diskette" appears.
7.
Insert "Configuration Diskette" into the floppy disk drive and click [OK].
NOTE: If you do not have "Configuration Diskette", insert a blank
floppy disk formatted by 1.44MB into the floppy disk drive and click
[OK].