NEC Express5800/120Ei, Руководство пользователя

Страница: 265 / 414

Troubleshooting 8-27
Problems with NEC EXPRESSBUILDER
When the server is not booted from the NEC EXPRESSBUILDER DVD, check the following:
T
Did you set the NEC EXPRESSBUILDER during POST and restart the server?
→
If you do not set the NEC EXPRESSBUILDER during POST and restart the
server, an error message will appear or the OS will boot.
T
Is BIOS configuration correct?
→
The boot device order may be specified with the BIOS SETUP utility of the server.
Use the BIOS Setup utility to change the boot device order to boot the system
from the optical disk drive first.
<Menu to check: [Boot]>
If [OS installation ***default***] is selected at BOOT Selection screen, following message is
displayed.
After this message appears, check the error and take the appropriate corrective action according to
the message listed in the table below.
Message Cause
This EXPRESSBUILDER version was not designed
for this computer.
Insert the correct version and click [OK]. (When you
click [OK], the computer reboots.) This NEC EXPRESSBUILDER version is
not designed for this server.
Execute the NEC EXPRESSBUILDER on
the compliant server.
EXPRESSBUILDER could not get the hardware
parameters written in this motherboard.
This version is not designed for this computer or the
motherboard may be broken. (When you click [OK],
the computer reboots.)
The hardware parameters written in this
motherboard are incorrect.
This version is not designed for this computer or the
motherboard may be broken. This message is shown when NEC
EXPRESSBUILDER could not find system-
specific information because of mother
board exchange and so on.