1. POST Error Message
Express5800/T110f-S, R110f-1E, T110f-E Maintenance Guide
138
Chapter 3 Appendix
(2) Beep
code
If POST detects a problem and is unable to display the error message, the beep code sounds instead of
displaying the message.
A beep code is a series of short beeps separated by pauses. For example, "1-3-3-1" indicates one beep, a
pause, three beeps, a pause, three beeps, a pause, and one beep.
The table below shows the beep code, descriptions, and recommended actions.
Beep Code
Description
Action
1-3-3-1
No memory in the server.
Make sure that the DIMMs are correctly
installed. If the DIMM is installed correctly,
contact your sales representative.
1-5-2-1
No processor in the server.
Make sure that the processor is correctly
installed. If the processor is installed correctly,
contact your sales representative.
1
An error occurred during the POST
processing.
Contact your sales representative.
2
Updated BIOS data was detected.
Wait until BIOS update completes.
3
Reading or running the BIOS executable
module failed.
Contact your sales representative.
4
Initializing the BIOS executable module
failed.
Contact your sales representative.
5
No graphics controller in the server.
Contact your sales representative.
7
Resetting the system failed.
Contact your sales representative.
8
An error was detected during allocating the
PCI resources.
Remove all the PCI boards from the PCI slots,
and then reboot the server.
If the error is detected again, contact your sales
representative.
