5. Troubleshooting
Express5800/T110f-S, R110f-1E, T110f-E Maintenance Guide
36
Chapter 1 Maintenance
Is option board setting correct?
→
Usually, no PCI device settings need to be changed. However, depending on the board to be set,
special setting may be required. Refer to the manual that comes with the board for details to make
correct settings.
→
Some devices connected to the serial or parallel port, or USB port may require I/O port address or
operation mode settings. Refer to the manual that comes with the device to make correct settings.
[?]
The keyboard or mouse does not work
Is the cable properly connected?
→
Make sure that the cable is connected to the connector on the front or rear
of the server.
Is BIOS configuration correct?
→
You can use the BIOS setup utility to change the keyboard feature. Check the BIOS configuration with
this utility.
Are the server drivers installed?
→
Refer to the manual that comes with your OS to check that the keyboard and mouse drivers are installed.
(These drivers are installed along with the OS.) Some OS’s allow you to change the keyboard and
mouse settings. Refer to the manual to check that the keyboard and mouse settings are correct.
[?]
Unable to access the Hard Disk Drive
Is the Hard Disk Drive supported by the server?
→
Operation of any device that is not authorized by NEC is not guaranteed.
Is the Hard Disk Drive properly installed?
→
Check the Hard Disk Drive installation status and the cable connections.
[?]
The numbers assigned to the Hard Disk Drive bays do not match the numbers indicated in the OS.
Is the SATA drive connected in IDE mode?
→
In SATA IDE mode, the drive bays might be recognized in a different order from the physical connection,
depending on the OS used.
Primary > Secondary
Master > Slave
Port0 : Primary Master
Port1 : Secondary Master
Port2 : Primary Slave
Port3 : Secondary Slave
Port4 : Primary Master
Port5 : Secondary Master
Group1
Group2
